Electrical grounding

[Bill Cleveland]

Other than grounding from negative Battery cable to frame, what ground straps/wires are you using in your T?

[mike wade]

Spanky You can never have to many grounds. I go from the Batt to the frame after I use a post for all the wiring on the inside of the car. Then from the engine to the frame as close to the starter as I can. From the block on the other side to the frame also. In a fiberglass car the more grounds the merrier/happier it will be..........

[Dennis Neblock]

Mike is right on!!!! On top of that, for the higher tech folks, any electronic computers (i.e. fuel injection) should ground directly to the battery.
For us low tech folks , that few ohms of resistance in the frame, block, etc. doesn't make a difference. However , on the electronics side, that drop of maybe .1 or .2 volts does make a difference. So, ground up!!!!