New T Bucket.............

[mike wade]

This is gona take some doing.................. .....But we is gona build one to sell cause we got parts...........

DSC00680.JPG (844.92 KiB) Viewed 1160 times

DSC00681.JPG (829.16 KiB) Viewed 1160 times

DSC00682.JPG (879.89 KiB) Viewed 1160 times

DSC00683.JPG (875.14 KiB) Viewed 1160 times

DSC00687.JPG (850.38 KiB) Viewed 1160 times

That pile of wood on the floor is the bucket floor even after some of it was hauled to the trash........just a tad rough & it had been very wet........

[Uncle Larry]

How long did it take you to grind all that yellow paint off it???? LMAO

[Uncle Larry]

Good looking steps on Yelot, good design. Easier for Angel also

[Bill Cleveland]

Paint it red; put a Chevy in it. It'll sell . . .

[mike wade]

Paint it red; put a Chevy in it. It'll sell . . .

Well if that is what is required Spanky I will have two buckets for awhile.........

Uncle Larry I don't like to sand that much...............

[mike wade]

Good looking steps on Yelot, good design. Easier for Angel also

Hell if I know her and I do she won't even use them.......

[winfield scott]

You aren't going to use any of that Damn Stainless on that new bucket are you??

[mike wade]

You aren't going to use any of that Damn Stainless on that new bucket are you??

Windy I don't know how to use that stuff, it is too tough for me.........LOL.....

[mike wade]

Still digging out rotten wood to start with a new floor...........

DSC00685.JPG (843.61 KiB) Viewed 1136 times

DSC00686.JPG (669.52 KiB) Viewed 1136 times

[Bill Cleveland]

Hey, Mike . . . why not build a recessed floor, with footwells that drop down between the frame rails? Would allow a lower seating position without sacrificing leg room.