SST update

VroomKrazy · Post by **VroomKrazy** » Fri May 20, 2016 8:30 am

Bruce that looks good

but I think it is upside down

mike wade · Post by **mike wade** » Fri May 20, 2016 9:13 am

This is one I took in Amarillo of Bruce's setup and I think it is up right..........Nice just like the other ones in use..........I guess I will get-er done soon..........May not for the Nats but sooner rather than latter.......

Bill's parts yard in Amarillo had many cars just like this........

.I could spend many hours there just drooling...................

Mike

cecil misner · Post by **cecil misner** » Fri May 20, 2016 12:24 pm

So, Windy, You mentioned that the steering feel is significantly easier. If the car is sitting, is it easier? Please elaborate. CEEEEEEC

winfield scott · Post by **winfield scott** » Fri May 20, 2016 1:29 pm

cecil misner wrote:So, Windy, You mentioned that the steering feel is significantly easier. If the car is sitting, is it easier? Please elaborate. CEEEEEEC

Sitting still the steering is much easier, the rack and pinion transfers the lineal motion much better than a rotating shaft and pitman arm with a lot less stress.

cecil misner · Post by **cecil misner** » Mon May 23, 2016 9:14 pm

Would you disclose the estimated cost?

winfield scott · Post by **winfield scott** » Tue May 24, 2016 4:24 am

Rack was $300 + 2 universals @ $30 each
Everything else like the bracket & drag link I made.
So really not much more than a Corvair setup.

cecil misner · Post by **cecil misner** » Sat May 28, 2016 2:58 pm

Windy, That is damn near a bargain. Your skills are obvious. My thoughts are spinning as I plan my remodel.
.

National T-Bucket Alliance

SST update

Re: SST update

Re: SST update

Re: SST update

Re: SST update

Re: SST update

Re: SST update

Re: SST update